Jump to content

Astonished...once again!


Recommended Posts

From what I am learning in the forum, tightening too much the screws may damage the ribbon assembly and too little allows buzzing. How does the original factory assembly avoid this? I would be in interested in learning how the factory assembles the ribbon components. My imagination runs off to some miniature torque wrench that should be in my tool kit. Perhaps someone in-the-know here would like to share insight into this matter. Back to listening again today and minimal (1/8-ish) turns. So far each screw1/8 turn has met no resistance of the kind sensed when a screw has reached or is very near the stop point.  Pat Metheny recordings, his electric guitar tone, reliably buzzes, so it will be Pat & me today.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...