Jump to content

Recommended Posts

Posted (edited)

Managed to finally acquire correct on off push-button assy replacement as well as the new button cap (which was all I needed) for my MXR 130. Also used a small section of Alien-tape to secure the front control panel, could not see how it was factory installed. Did manage to lose the 6 cabinet cover screws and now need to find suitable replacements before I hook up my entire entertainment system.  Ordered 8/36 1/2" that did not fit, close but would not thread in. The MXR-130 will be the center of my audio setup.  It will have a Denon DP-200USB turn table, Polk XM tuner XRt12, CD, MD, dual Marantz PMD300CP cassette, Pfantone SS-2 pre-preamp(for my turntable MC cartridge) and a Harmon Kardon BTA10 bluetooth(modernize .. aux input?). Have an input switch box which may be kind of "dirty" and a Marantz AT-6 audio digital timer I was hoping to fit in if I can figure out how to use it. 2 sets of tower speakers Kirsch and Advent .. will have to see which sound better. Need to acquire clean hookup wiring though I have the Monster cable I will use for speakers. Any helpful input apprecated :)

Edited by keithnh
add
  • Thank You 6
Posted

I'll echo @Yamacarver that your BT receiver can connect right to your AUX input. However, you did mention that your current input switcher was a bit 'dirty', so you may want to think about investing in a new switcher. For an inexpensive unit, I have been impressed by the switchers from Douk Audio. They have completely passive units but also some active units that have BT receivers built in along with clocks, spectrum analyzers, level controls, remotes, etc.

  • Thank You 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...