treitz3

Mark, raise the two front subs up to tweeter level. You can thank me later. Tom

This guy......this guy....... There are 3 people in the foreground. Mark pops up like, "Where's Waldo"? Slacker.... He has some of the BEST taste in music. "Mark" my words... Tom

Hello, Chris. We always discuss his creations. Bob is no stranger to discussing anything and everything when it comes to audio. Bob was doing fine until about day three, when he was quarantined due to apparently contracting COVID. He is getting older (obviously) as time marches on and while he was moving slowly, he's still up and about when he can be. Peggy is taking great care of him and his needs. He had an "incident" before flying out, so he is wearing an arm sling. He went to go get out of his vehicle at home (his driveway is on a slope), and got off balance. When he went to go grab the car, his hand slipped, so he kept going down the driveway trying to regain his balance and gravity ended up getting the better of him. He landed on the ground toward the end of the driveway and hit pretty hard, parallel to the ground. He was in good spirits (as always) and he's still full of spunk, when it comes to talking shop about audio. I'm not quite sure if he will be able to make it to another CF. I know full well that his mind says, "YES" but his body is telling him another message. We can always hope, but I wouldn't hold your breath. Tom

Some of the photos I took while I was there...so those who could not make it can live vicariously through the start of the event. Tom

Hey, all. Tom here. I made it home safe and sound (the ladies wanted to know....the men could have cared less). Thanks everyone for such a great time!!! It was nice to see the gang again and listen to some great tunes. Tom

Did you change the location of any of the power cords, IC's or anything else such as your speaker cables when you changed components? Any added appliances, lights or dimmer switches on that circuit?

Balok, if you do look into seriously getting a flattening machine? Furutec. Great results so far from a multitude of users. If we can get enough folks into purchasing one, we can all be co-owners and pass it around for a certain time to each owner....then mailing it on to the next owner. Each time the "owner" gets it, clean and flatten all new records and send it on it's way to the next owner. There are a select few at CP that have done this for some time now with no issues.