Leaderboard

It will power up with the radio //etc display lit up and will switch functions however there are only 1 LED showing in each volume indicator and no output to the speakers no matter what I do. I changed out the Relays and the Toshiba selector IC and the usual charred resistors already. There is only one click on power up so my question is what is the startup routine and how is it done _R/C delay circuit I am guessing ! I am thinking it probably needs the power supply capacitors changed out but there is probably a voltage test point or two I can verify if the switcher supplies are working ?? Also I see references to a cap that should be changed that is located near the radio IC so what are the symptoms if this cap is bad or going bad ?--Thanks in advance for any help

My radio can't seem to find any stations or make any sound to the speakers but it lights up with the station numbers and can manually move up and down the spectrum OK I cleaned the monitor switches and worked them back and fourth with deoxit . I had previously changed out the digital switch IC --any ideas where to go next --oh-- the AMP with AUX in works OK with a blurtooth adapter

Welcome to the Carversite Jim. I also have the 150 and love it. After reading that the relays click after turning on the receiver and you replaced them, I just want to make sure that you have the jumpers installed in the back of the receiver. And yes on replacing the filter caps during a tuneup. If you can access the manuals yet, all the procedures and bulletins are in there. Good luck with the project. Rob