Jump to content

w3wilkes

Novice
  • Posts

    10
  • Joined

  • Last visited

Personal Information

  • Location
    Layton, Utah, USA
  • Occupation
    Retired

w3wilkes's Achievements

1/4W Resistor

1/4W Resistor (3/21)

15

Reputation

  1. Funny, we're also in Layton. Just north of Mutton Hollow about 1/2 mile below 89.
  2. Wondering if there's many of you Carver folks using Squeezebox? I've been in the SlimDevices - Logitech Squeezebox - now Lyrion music world since 2008 for all my digital music. Wilkes
  3. Thanks, didn't realize the pre was less deep than the amp. I think I can put the pre on a shelf above the amp.
  4. Thanks again to all for your answers and input! Always wanted a little more power than my old Kenwood KA-405 55 watt integrated amp to drive my old ADS-L810's and now in a position to afford an upgrade. Just pulled the trigger on a Carver C1 preamp and a Carver M-1.0t with the switch on the back. Over the years I've read a bunch of stuff on Bob Carver, gear designs and some the challenges he gave to the "tube purist's". So looking forward to hooking these up! Would it be better to stack the amp on the preamp due to heat from the amp, seems to make sense? Wilkes
  5. I'm also thinking of trying Sonic Holography. The C1 preamp seems like it would be just fine for me. In reading the C1 manual it sounds like the use of SH requires specific positioning of the speakers in relation to the listener and would be more for "individual critical listening". Then for casual listening in a social setting it would probably be best to shut off SH. Does this make sense?
  6. Thank you all. My use would be a single amp with 2 speakers (ADS L810's) attached left and right. Just hook them up per normal + to + and - to - for both left and right on the pre 4500 amp or the same on a newer than 4500 amp with the switch in Stereo position, correct?
  7. Hi all, I'm old and retired but have always thought Carver had great products! I'm looking to get a preamp and amp. Been looking at the M1.0t amp and notice there's a pre and post version from serial # 4500. The post 4500 serial # has a switch for mono vs stereo that isn't on the pre SN # 4500 units. If connecting 2 speakers (stereo) should the + and - match or are the left and right channels out of phase? If out of phase, should one of the speakers be connected reversed? Wilkes
×
×
  • Create New...